Universal Water Based Epoxy Coating is a simple to use water based epoxy coating that is suitable for most applications where concrete or masonry require waterproofing or a protective coating. It is easy to apply and no more difficult to use than a conventional emulsion paint but can even be applied to damp substrates. Once cured you are left with a tough, non toxic, waterproof and easy to maintain finish.

Suitable Applications:

• As a waterproof membrane to prevent rising damp in floors.
• As a general purpose waterproofing treatment and decorative finish for any brick, concrete,masonry and cement surface.
• As a coating for damp surfaces where adhesion would be an issue for other coatings.
• For sealing asbestos based materials.
• For waterproofing basements and cellars
• For sealing recently laid concrete floors to allow the rapid laying of flooring such as tiles or boards.
• As a tank or bund lining for protection against mild chemicals
• As a hard wearing floor coating for garages and workshops
• As a primer for our Epoxy Floor Paint when a high quality finish is required.

Typical Areas of Use:

• Basements and cellars
• Food manufacturing and storage
• Garages and workshops
• Dairies, milking parlours and breweries
• Abattoirs and fisheries

Coverage:

Approximately 6 - 7 m² per litre per coat. Coverage can vary significantly depending on the porosity and condition of the substrate.

Colours:

Available from stock in clear, white, black and light grey. Other colours are available to order. Please see our Epoxy Floor Paint for a wider range of colours.

Size:

Available only as a two part product that when mixed and combined with cold water gives 5 litres.

Application:

Universal water based epoxy is designed to be a two part system but where the surface is very porous or when being used as a damp proof membrane a third coat is recommended. When applying to a porous substrate we recommend diluting the first coat by an additional 10% with clean cold water to help with coverage.

Please Note:

Water based epoxy must only be applied when the ambient and substrate temperature is above 10°C and should not be stored below 5°C. Because the pot life is approximately 1 -2 hours a separate tin will be required for each coat.

Due to ongoing issues with supply of this product - we have decided to withdraw if from our range.

Produxt Datasheet