AWL-PREP Auxillary Products

Awlcoat TPC is a water-based temporary protective coating.

They contain just enough resin to remove light dust particles from an otherwise clean surface. Tacking off the surface is the last step before applying the topcoat.

Griptex Professional Non-skid Particles: 73012, 73013 and 73237 for AWLGRIP and AWLCRAFT 2000 Topcoats.

PRO-CURE Accelerators may be used to decrease dry and cure times in AWLGRIP and AWLCRAFT 2000 Topcoats. Do not use in primers. Fast Accelerator for Urethane Topcoats. (Spray Only)

PRO-CURE X-98 (73014) 1/2 liquid ounce per 2 gallons of mixed topcoat color base and converter. This is the maximum amount; lesser quantities may be sufficient

Inhibited Accelerator for Urethane Topcoats. (Spray or Brush)

G1010 Flattening Agent.

CRATER-X is an additive developed for use with AWLGRIP and AWLCRAFT 2000 Topcoats to prevent cratering, crawling, and fisheyes caused by minor surface contamination.

CRATER-X alters the surface tension of the coating improving flow and leveling. Use CRATER-X after a surface contamination problem has been identified and corrected, or whenever the quality of surface preparation is in doubt.

CRATER-X is not a substitute for proper cleaning or surface preparation. It will not overcome severe surface contamination conditions.

CRATER-X is to be used in topcoats only--never add it to primers.

COLD CURE Accelerator for 545 Primer reduces cure and recoat times for 545 Primer by as much as 50%. Add up to 12 1/2% of catalyzed volume of 545 Primer, replacing that amount of standard reducer. Use between 50 F and 75 F