View Questions by Category
Antifouling boats. (11)
|
Bilges (1)
|
Decks (4)
|
|
Epoxies such as West Epoxies and Epiglass (15)
|
Hull above the waterline (8)
|
Hull below the waterline (6)
|
|
I just want some basic advice for a straightforward job. (10)
|
Masts (1)
|
My paint job has gone wrong (2)
A description from the Blakes' paint guide of common painting faults
|
|
Odd and Ends (5)
|
Questions about specific paint products (2)
- as and when we get questions specific to a particular paint we put them here
|
Varnishing (3)
|
|
What is ?????? - what a paint word means (1)
|
Most Popular Questions
Why do you need to test for a two pack paint and how do you do it?- Could you please tell what type of paint I need to paint a fibreglass boat?
- I have a dear old (1938) clinker built boat that needs repainting, can you advise on the best type of paint and also whether it will be OK for the paint if I leave the boat in the water. Will I need t
- How do I paint using a two pack top coat such as International Perfection?
- Can you show me how to paint a boat?
- I want to paint a narrow boat
- I would like a paint guide/booklet on how to paint a boat or narrowboat?
- GRP yacht in dry dock ,no Gelcoat, but has polyester fillers. What do I do?
- Common paint problems
- I am looking for hard wearing non-slip deck paint for the sole of our boat. The sole and boards have just been replaced and glassed in. Is there an advantage to coating the bare ply with polyester res
Recent Entries
- I would like a paint guide/booklet on how to paint a boat or narrowboat?
- Any thoughts on final finishing, eg rubbing down with fine grade wet paper and/or other abrasive on VC17M Graphite and VC17 Offshore ?
- Can you supply rollers which are solvent resistant and give the smoothest finish - I have had trouble with "orange peel" and disinitegrating rollers.
- VC17M Graphite and VC17 Offshore which one to use
- The topsides was once glossy but has now flattened and discoloured with age. Basically I want a gloss finish o
- The best International Paint Deck finishes - a small experiment.
- Gelcoat removed replaced with VC Tar now I want Gelshield. How?
- Following a minor accident, I now have a 9-inch wide hole right through the hull (Fibreglass), just above the waterline on starboard side. How can I repair this?
- How long do epoxies really take to cure?
- My boat encounters a harsh UV challenge, how can I optimise UV protection when using Epiglass?